description:
The digital displays DA are used as indicators by using external sensors with 0-10 V or 4-20 mA output.  If necessary it can be used for adjust the zero-point of the connected sensor. At many applications the sensor is installed at difficult accessible places. Therefore it is often difficult to adjust the zero-point direct at the sensor. The digital-displays makes it possible to add or subtract a correction voltage or current to the sensor signal.
The aluminium housing has a high mechanical stability and good EMV- properties. It is suitable for installation into a control switchboard. If the input signal passes the critical value 20 mA or 10 V a red LED on the front  indicates the overload of the sensor. DA can be completed with several additional options: two switching outputs, RS232-interface or 4-20 mA transmitter.
 

operation temperature range:

-20 bis +50 C
 

power supply and input signals:

U_s optionally:   15-24 VDC or 230 VAC +/- 10 %

analog-input type DA 420: 4-20 mA
R_{b 4-20} = 100

analog-input type DA 010:  0-10 V
 

connections:

plug with 7-pole depht clamp for 0,14-1,5 mm²
 

optionally switch output:

loadability: max. 230 VAC 1A
switch hysteresis: approximately 2 % full scale
 

optionally RS-232 interface:

data format: 8 bit without parity-bit, 1 stop-bit (8N1)
baudrate: 9600
handshake: xon / xoff
 

optionally 4-20 mA transmitter:

output:  4-20 mA
0-20 mA also possible

weight:

approximately 350 g
 

protection class:

IP 54 (front)